Special Systems

The FineFocus 800 cuts reliably and offers good cut quality even under extreme conditions. At the same time it achieves high efficiency due to the low gas consumption. Electrically conductive materials with a thickness of 5 mm to 80 mm can be cut reliably. The plasma cutting unit can be adapted to CNC-controlled guiding systems and robots quickly and easily. With FineFocus 800 it is possible to use also compressed air as plasma gas.

The FineFocus 800 is used especially for the dismantling of nuclear facilities as well as for manual plasma cutting and gouging. For the dismantling of nuclear facilities, it is possible to connect up to three machines in parallel to meet the higher performance requirements.

For manual plasma cutting, there is the possibility to use air as plasma gas but also technical gases (argon, hydrogen).

Contact person
Plasma Cutting Technique

Mrs. Coren BÖTTGER

phone +49 3531 500-226
email

Send e-mail now

Special Systems

The FineFocus 800 cuts reliably and offers good cut quality even under extreme conditions. At the same time it achieves high efficiency due to the low gas consumption. Electrically conductive materials with a thickness of 5 mm to 80 mm can be cut reliably. The plasma cutting unit can be adapted to CNC-controlled guiding systems and robots quickly and easily. With FineFocus 800 it is possible to use also compressed air as plasma gas.

The FineFocus 800 is used especially for the dismantling of nuclear facilities as well as for manual plasma cutting and gouging. For the dismantling of nuclear facilities, it is possible to connect up to three machines in parallel to meet the higher performance requirements.

For manual plasma cutting, there is the possibility to use air as plasma gas but also technical gases (argon, hydrogen).

Inquire Now
Power source FineFocus 800
Mains voltage* 3x 400 V, 50 Hz
Cutting current (at 100 % duty cycle) 300 A
Cutting range 5 - 80 mm
Piercing up to 40 mm
Plasma gases O2, Air, Ar, H2, N2
Dimensions (L x W x H) 1375 x 870 x 1505 mm
Weight 556 kg
Plasma torch


 PB-S80 W
PB-S80 WSM
PB-S75 WH-1

*Other voltages and frequencies available upon request.

PLUS
Cutting mild steel with small angular deviation

Automated & Manual
Can be used in CNC mode as well as for manual plasma cutting

Go back