HiFinox, Ar/H2 Mix & N2
Plasma Cutting of Stainless Steel and Aluminium from 1 to 160 mm
The HiFinox technology is used for plasma cutting of stainless steel and aluminium from 1 to 6 mm. Users benefit from metallically bright cut surfaces, narrow kerfs and significantly less dross formation.
HiFinox cathodes are available for the plasma power sources Q, Smart Focus and HiFocus. Due to the new design of the cathodes, the optimised production process and the new technology that is registered for patent the lifetime of the cathodes is increased considerably – with a cutting current of 60 A by factor 5 to 10.
For plasma cutting of stainless steel and aluminium sheets with a thickness between 6 and 160 mm, the plasma power sources Q, Smart Focus and HiFocus are equipped with the Ar/H2 mix technology. The plasma gases are mixed for each specific job to achieve best cutting results and high cutting speeds. Inner and outer contours can be cut with a very good contour accuracy, angularity, and surface quality. Time-consuming rework may not be required anymore.
N2 Plasma Cutting
With the plasma power sources of the Q series it is possible to cut stainless steel and aluminium in the material range up to 60 mm as well with nitrogen. The user benefits from good cutting results and small angular deviations as well as high cutting speeds, especially in the lower material thickness range. By using nitrogen as plasma gas allows the user achieves cost savings and more flexibility.
The N2 technology thus provides the user with an alternative to the Ar/H2 technology.
Plasma Cutting of Aluminium and Stainless Steel with Nitrogen
Plasma Cutting of Stainless Steel and Aluminium with Very Good Cut Quality | HiFinox Technology
Plasma Cutting of 120 mm Stainless Steel