PlasmaLaserServiceAbout us Contact
Cutting Equipment | About us | News | New inverter CutFire 100i

News


Precise laser cuts with XFocus
Strong Start for Fiber Faser
International demand for XFocus systems

Training Courses on Bevel Cutting
Now on Offer – Training Courses on Bevel Cutting
The training programme of the Kjellberg Academy is available from now on

03 May 2017

New inverter CutFire 100i

CutFire 100i cutting thin sheets As of now Kjellberg offers a new inverter CutFire 100i to further improve the cutting performance of the well-proven CutFire series for plasma cutting with air: The cutting inverters CutFire 100i built in or after 2017 are equipped with the new machine torch Flash 101 and uses air now also as swirl gas.

The air rotating around the plasma arc stabilizes the arc and thus enables cutting up to 30 mm and piercing up to 20 mm. Besides, the cooling and protective effect of the swirl gas ensures higher cutting speeds and an increased lifetime of the consumables.
 
Further information
 
Plasma torch Flash 101 Plasma inverter CutFire 100i in usage

Back
Contact | Legal Notice | General Terms and Conditions | Disclaimer | Privacy Statement | RSS | PDF Printing
CLOSE